OP, the whole point of setting a curve is that the system will respond automatically to changing temperatures so that you don't have to. However once you get into Corsair's proprietary fan hubs and controller modules, they only connect to the motherboard via USB, at which point you need software that can 'speak' the right protocols as far as I'm aware, this means you have to use their software. In either instance though, they're running just fine off generic, standard PWM signals. They're currently hooked up (via an Arctic Cooling PWM splitter) to a cheap standalone thermal sensor PWM control PCB, to get around the fact my X570 motherboard doesn't have a temperature sensor header. My custom loop is nine Corsair ML fans (non-RGB) and they ran fine off the motherboard headers on my Asus Z370. Previously I had a profile for general use, and one that I toggled on before I started a game (headphones = I don't care if the fans are loud) and that is basically what I want to go back to. This means that I would either have to have two apps to control cooling, or drop ~$80 on a new Corsair fan hub. Now they have iCUE and while I have it for my AIO, the Commander mini fan controller hub that I have had & used for around 5 years, is not compatible with the new software. I will give them a try, but I still don't like having to restart to get to the controls.įor several years I have been using the Corsair link software, and other than some problems with their crappy 'Link' software a couple years back, I was fine with it. Yes my fans are PWM and I did look at the UEFI fan controls last night after you mentioned it, and there is a way to set curves. PSU: EVGA SuperNOVA 750 G+, 80 Plus Gold 750W RAM: G.SKILL Ripjaws V Series 64GB (2 x 32GB) 288-Pin DDR4 SDRAM DDR4 3600 Mobo: MSI MAG Z490 TOMAHAWK LGA 1200 Intel Z490ĪIO: CORSAIR iCUE H150i RGB PRO XT, 360mm (we keep the house around 23) I would be just fine with the case fans not spinning (with the AIO fans at low RPM) until temps hit the high 30's, and then ramping up.

Most of the time my idle temps for CPU & GPU are around 28-30.

How can i use hwinfo to control fan